Displaying Etherchannel, Pagp, And Lacp Status - Cisco 2950 - Catalyst Switch Configuration Manual

Displaying EtherChannel, PAgP, and LACP Status

Step 3 end
Step 4 show running-config
or
show lacp channel-group-number internal
Step 5 copy running-config startup-config
Displaying EtherChannel, PAgP, and LACP Status
You can use the privileged EXEC commands described in
and LACP status information:
Table 31-3 Commands for Displaying EtherChannel, PAgP , and LACP Status
Command
show etherchannel [channel-group-number] {detail |
load-balance | port | port-channel | summary}
show pagp [channel-group-number] {counters |
1
internal | neighbor}
show lacp [channel-group-number] {counters |
2
internal | neighbor}
1. You can clear PAgP channel-group information and traffic filters by using the clear pagp {channel-group-number
EXEC command.
2. You can clear LACP channel-group information and traffic filters by using the clear lacp {channel-group-number
EXEC command.
For detailed information about the fields in the command outputs, refer to the command reference for
this release.
Catalyst 2950 and Catalyst 2955 Switch Software Configuration Guide
31-14
Return to privileged EXEC mode.
Verify your entries.
(Optional) Save your entries in the configuration file.
Table 31-3
Description
Displays EtherChannel information in a detailed and one-line
summary form. Also displays the load-balance or
frame-distribution scheme, port, and port-channel information.
Displays PAgP information such as traffic information, the
internal PAgP configuration, and neighbor information.
Displays LACP information such as traffic information, the
internal PAgP configuration, and neighbor information.
Chapter 31 Configuring EtherChannels
to display EtherChannel, PAgP,
[
counters] | counters} privileged
[
counters] | counters} privileged
78-11380-10