Configuring Etherchannels - Cisco 2950 - Catalyst Switch Configuration Manual

Chapter 31

Configuring EtherChannels

Figure 31-3 Load Distribution and Forwarding Methods
Configuring EtherChannels
These sections describe how to configure EtherChannel interfaces:
•
•
•
•
•
Note Make sure that the interfaces are correctly configured (see the
section on page
After you configure an EtherChannel, configuration changes applied to the port-channel interface apply
Note
to all the physical interfaces assigned to the port-channel interface, and configuration changes applied
to the physical interface affect only the interface where you apply the configuration.
78-11380-10
Switch with
source-based
forwarding enabled
EtherChannel
Cisco router
with destination-based
forwarding enabled
Default EtherChannel Configuration, page 31-8
EtherChannel Configuration Guidelines, page 31-8
Configuring Layer 2 EtherChannels, page 31-9
Configuring EtherChannel Load Balancing, page 31-11
Configuring the PAgP Learn Method and Priority, page 31-12
31-8).
"EtherChannel Configuration Guidelines"
Catalyst 2950 and Catalyst 2955 Switch Software Configuration Guide
Configuring EtherChannels
31-7