Table of Contents
Advertisement
Chapter 3
Managing Linksys 900 Series IP Phones
•
Attended Call Transfer
An attended call transfer allows a user to optionally transfer a call to a third party, after having
a discussion with that third party. There are two ways to perform an attended call transfer:
•
•
While one or more call appearances is on hold, initiate a call on an idle line key. While the call
is either ringing or is connected, press the xferLx line key. If only one other call is on hold, the
active call is connected with the call on hold. Otherwise, the user is prompted to select to which
line key to transfer the call.
At the completion of call transfer operation, the holding call peer is the transferee, and the
connected or proceeding call peer is the transfer target. The case where a call transfer is
completed when the transfer target is ringing is called a semi-attended call transfer. This is
different from a blind transfer, which is described in the next subsection.
Blind Call Transfer
A blind call transfer allows the user to transfer a call without speaking with the receiver of the
transferred call. For the user, the call ends as soon as the transfer target phone number is dialed.
The user phone sends the contact information for the transfer target to the phone of the other
party on the call. The information is carried in a signaling message. When the message is sent,
the user phone is dropped from the call and the other party phone automatically dials the
transfer target.
To perform a blind call transfer, press the bxfer soft key and then dial the target number. The
bxfer soft key automatically becomes active during a call, but it may not be visible on the
display. If the bxfer key is not visible, press the left/right arrows on the Navigation button until
it scrolls onto the display.
Some SPA phones do not have bxfer soft keys. To perform a blind transfer on these devices,
during the call, press the xfer soft key, or the line key of an unused line. There must be a spare
line available to perform the transfer. Once the new dial tone is heard, enter *98. The phone
prompts the user to enter the phone number of the transfer target. Enter the number to complete
the blind transfer. If the user phone has more than one call on-hold on, the last call placed on
hold is the one transferred.
Document Version 3.0
Ringing call cannot be brought into a conference by pressing the confLx soft key; only calls that are
on hold can be brought into the conference with the confLx soft key.
During an active call, press the xfer soft key to place the current call on hold and to activate an idle
line key.
Dial the transfer target number on the newly activated line. When the target is either ringing or
answered, press the xfer soft key again to complete the transfer.
Linksys 900 Series IP Phone Administrator Guide
Using Call Features
3-15
Advertisement
Table of Contents
