Problems After Installing The Driver; Client Adapter Recognition Problems - Cisco AIR-PCM342 Hardware Installation Manual

Chapter 4 Troubleshooting and Routine Procedures

Problems after Installing the Driver

Note

Client Adapter Recognition Problems

Note
OL-0795-01
Table 4-1 LED Operating Messages (continued)
Green LED
Off
On
Off
Off
If you experience problems during driver installation, you may want
to restart the installation process. Go to the "Removing the Driver"
section on page 4-9 to start with a clean install.
Follow the instructions in this section if you experience difficulty with your client
adapter after installing the driver (for instance, your computer repeatedly freezes
at the network login screen, the green LED does not blink to indicate that the
adapter is active, etc.).
If your client adapter is not being recognized by your computer's PCMCIA
adapter, check your computer's BIOS and make sure that the PC card controller
mode is set to PCIC compatible.
A computer's BIOS varies depending on the manufacturer. For
support on BIOS-related issues, consult your computer's
manufacturer.
Cisco Aironet Wireless LAN Adapters Hardware Installation Guide
Amber LED
Blinking quickly
Blinking quickly
On
Blinking in a pattern

Problems after Installing the Driver

Condition
Client adapter is in power save
mode.
Client adapter is in ad hoc mode.
Driver installed incorrectly.
Indicates an error condition.
4-3