Installing The Driver For Windows 95; Windows 95 Version A - Cisco AIR-PCM342 Hardware Installation Manual

Chapter 3 Installing the Client Adapter

Installing the Driver for Windows 95

Note

Windows 95 Version A

Step 1
Step 2
Step 3
OL-0795-01
Windows 95 limits your computer's network connections to four. If
you try to install a client adapter when four network devices (such
as a PCMCIA Ethernet card, dial-up adapter, VPN adapter, docking
station Ethernet card, etc.) are already connected to your computer,
the new adapter cannot establish a network connection.
The driver installation instructions vary for Windows 95 Version A and Version
B. You can determine which version your computer is running by selecting My
Computer, Control Panel, System, and General. The version of your
computer's operating system is located under the System heading. If you have
Windows 95 Version B, the version number ends with the letter B.
For Windows 95 Version A driver installation instructions, go to the
•
"Windows 95 Version A" section below.
For Windows 95 Version B driver installation instructions, go to the
•
"Windows 95 Version B" section on page 3-9.
If your computer's operating system is Windows 95 Version A, follow these
steps.
Insert the Cisco Aironet Series Wireless LAN Adapters CD into your computer's
CD-ROM drive.
Copy the Win95Driver.exe file from the Win95 directory on the CD to a floppy
disk or to a directory (other than the root directory) on your computer's hard
drive.
Remove the CD from your computer's CD-ROM drive.
Cisco Aironet Wireless LAN Adapters Hardware Installation Guide
Installing the Correct Driver
3-7