Badtransceiver Messages; Bspatch Messages - Cisco IAD2424-8FXS - IAD 2424 Router System Message Manual

Ethernet access switches
Table of Contents

Advertisement

Chapter 2
Messages and Recovery Procedures
Error Message ACLMGR-3-UNLOADING: Unloading [chars] label [dec] feature.

BADTRANSCEIVER Messages

This section contains the BADTRANSCEIVER message.
Error Message BADTRANSCEIVER, PHY, LOG_WARNING: An innapropriate transceiver has
been inserted in interface [chars].

BSPATCH Messages

This section contains boot loader patch messages.
Error Message BSPATCH-1-RELOAD: System will reboot to activate newly patched Boot
Loader.
OL-9641-01
Explanation
This message means that the ACL manager was unable to fit the complete configuration
into the hardware, so some features will be applied in software. This prevents some or all of the
packets in a VLAN from being forwarded in hardware and requires them to be forwarded by the
CPU. Multicast packets might be dropped entirely instead of being forwarded. [chars] is the
direction (input or output), and [dec] is the label number.
Recommended Action
Use a simpler configuration. Use the same ACLs on multiple interfaces, if
possible.
This message means that a defective module is installed in the specified interface.
Explanation
[chars] is the interface.
Remove the transceiver. If it was purchased from Cisco, contact your Cisco
Recommended Action
representative to have the transceiver replaced.
Explanation
This message means that the switch will automatically reboot after the boot loader is
patched.
If this message recurs, copy it exactly as it appears on the console or in the
Recommended Action
system log. Research and attempt to resolve the error by using the Output Interpreter. Use the Bug
Toolkit to look for similar reported problems. If you still require assistance, open a case with the
TAC, or contact your Cisco technical support representative, and provide the representative with the
gathered information. For more information about these online tools and about contacting Cisco, see the
"Error Message Traceback Reports" section on page
1-4.
Cisco ME 3400 and 2400 Ethernet Access Switch System Message Guide
BADTRANSCEIVER Messages
2-7

Advertisement

Table of Contents
loading

Table of Contents