Cisco IAD2424-8FXS - IAD 2424 Router System Message Manual page 30

DHCP_SNOOPING Messages
Error Message DHCP_SNOOPING-4-NTP_NOT_RUNNING: NTP is not running; reloaded binding
lease expiration times are incorrect.
Explanation
snooping bindings and NTP is not running, the calculated lease duration for the bindings is
incorrect.
Recommended Action
system clock. Then disable and re-enable DHCP snooping to clear the DHCP snooping binding
database.
Error Message DHCP_SNOOPING-4-QUEUE_FULL: Fail to enqueue DHCP packet into
processing queue: [chars], the queue is most likely full and the packet will be
dropped.
Explanation
DHCP snooping process can handle. These DHCP packets are dropped to prevent a denial of service
attack. [chars] is the warning.
Recommended Action
Error Message DHCP_SNOOPING-4-STANDBY_AGENT_OPERATION_FAILED: DHCP snooping binding
transfer failed on the Standby Supervisor. [chars].
Explanation
standby supervisor engine. [chars] is the standby supervisor engine.
Recommended Action
Error Message DHCP_SNOOPING-6-AGENT_OPERATION_SUCCEEDED: DHCP snooping database
[chars] succeeded.
Explanation
DCHP snooping database.
Recommended Action
Error Message DHCP_SNOOPING-6-BINDING_COLLISION: Binding collision. [dec] bindings
ignored.
Explanation
switch read the database file. The bindings from the database file have MAC address and VLAN
information that a configured DHCP snooping binding already uses.
Recommended Action
Cisco ME 3400 and 2400 Ethernet Access Switch System Message Guide
2-10
This message means that if the DHCP snooping database agent loads the DHCP
Configure NTP on the switch to provide an accurate time and date for the
This message means that the CPU is receiving DHCP packets a higher rate than the
No action is required.
This message means that the DHCP snooping binding transfer process failed on a
No action is required.
This message means that the DHCP binding transfer process succeeded. [chars] is the
No action is required.
This message means that the specified number of bindings were ignored when the
No action is required.
Chapter 2 Messages and Recovery Procedures
OL-9641-01