Table of Contents
Advertisement
Chapter 2
Messages and Recovery Procedures
with the TAC, or contact your Cisco technical support representative, and provide the representative
with the gathered information. For more information about these online tools and about contacting
Cisco, see the
Error Message PM-4-LIMITS: The number of vlan-port instances on [chars] exceeded the
recommended limit of [dec].
Explanation
module or switch, has exceeded the recommended limit. VLANs can be counted more than once; if
VLAN 1 is carried on ten interfaces, it will count as ten VLAN ports. On some platforms bundling
is also ignored for purposes of this count; if eight interfaces on the same module are in one bundle,
and the port channel is carrying VLAN 1, it will count as eight VLAN ports. [chars] is the module
name (for example, switch or the module number), and [dec] is the recommended limit.
Recommended Action
as recommended in [dec]. Enter the show interfaces trunk privileged EXEC command to see the
total number of trunks and VLANs.
Error Message PM-4-NO_SUBBLOCK: No PM subblock found for [chars].
Explanation
[chars] is the interface name.
Recommended Action
Research and attempt to resolve the error by using the Output Interpreter. Enter the show
tech-support user EXEC command to gather data that might help identify the nature of the error.
Use the Bug Toolkit to look for similar reported problems. If you still require assistance, open a case
with the TAC, or contact your Cisco technical support representative, and provide the representative
with the gathered information. For more information about these online tools and about contacting
Cisco, see the
Error Message PM-4-PORT_BOUNCED: Port [chars] was bounced by [chars].
Explanation
the port manager restarted the port. A port can be restarted only when the port data structures are
not consistent in the active and standby supervisors. Active ports in the link-down state are returned
to the link-up state when the port is restarted (the re-activation event). The first [chars] is the port
number, and the second [chars] is the re-activation event.
Recommended Action
Error Message PM-4-PVLAN_TYPE_CFG_ERR: Failed to set VLAN [dec] to a [chars] VLAN.
Explanation
VLAN ID.
Recommended Action
Research and attempt to resolve the error by using the Output Interpreter. Enter the show
tech-support user EXEC command to gather data that might help identify the nature of the error.
Use the Bug Toolkit to look for similar reported problems. If you still require assistance, open a case
OL-9641-01
"Error Message Traceback Reports" section on page
This message means that the total number of individual VLAN ports, counted over the
Reduce the number of trunks and VLANs configured in the module or switch
This message means that the port manager failed to find the subblock for this interface.
Copy the message exactly as it appears on the console or in the system log.
"Error Message Traceback Reports" section on page
This message means that during a switchover when the port was in the link-down state,
No action is required.
This message means that the platform failed to set a private VLAN type. [dec] is the
Copy the message exactly as it appears on the console or in the system log.
Cisco ME 3400 and 2400 Ethernet Access Switch System Message Guide
PM Messages
1-4.
1-4.
2-47
Advertisement
Table of Contents
