Backup_Interface Messages; Badtransceiver Messages - Cisco IAD2423-16FXS-RF - IAD 2423 Router System Message Manual

Chapter 2 Messages and Recovery Procedures
Error Message ACLMGR-3-UNLOADING: Unloading [chars] label [dec] feature.

BACKUP_INTERFACE Messages

This section contains the Flex Link message.
Error Message BACKUP_INTERFACE-5-VLB_NON_TRUNK: Warning:
allowed on non-trunk ports.

BADTRANSCEIVER Messages

This section contains the BADTRANSCEIVER message.
Error Message BADTRANSCEIVER, PHY, LOG_WARNING: An innapropriate transceiver has
been inserted in interface [chars].
OL-9641-04
This message means that the ACL manager was unable to fit the complete configuration
Explanation
into the hardware, so some features will be applied in software. This prevents some or all of the
packets in a VLAN from being forwarded in hardware and requires them to be forwarded by the
CPU. Multicast packets might be dropped entirely instead of being forwarded. [chars] is the
direction (input or output), and [dec] is the label number.
Use a simpler configuration. Use the same ACLs on multiple interfaces, if
Recommended Action
possible.
Flex Link VLB detects a nontrunk port. [chars] is the interface name.
Explanation
Configure the interface to operate in trunking mode.
Recommended Action
Explanation This message means that a defective module is installed in the specified interface.
[chars] is the interface.
Remove the transceiver. If it was purchased from Cisco, contact your Cisco
Recommended Action
representative to have the transceiver replaced.
Cisco ME 3400E, ME 3400, and ME 2400 Ethernet Access Switch System Message Guide
Please configure [chars] to be a trunk port.
BACKUP_INTERFACE Messages
Flexlink VLB is not
2-7