Table of Contents
Advertisement
Chapter 2
Messages and Recovery Procedures
with the TAC, or contact your Cisco technical support representative, and provide the representative
with the gathered information. For more information about these online tools and about contacting
Cisco, see the
Error Message QOSMGR-4-POLICER_PLATFORM_NOT_SUPPORTED: Policer configuration has
exceeded hardware limitation for policymap [chars].
Explanation
the hardware. You configured together more policers in all policy maps (by using the police or
police aggregate policy-map class configuration command) than supported by hardware. [chars] is
the policy-map name.
Recommended Action
some interfaces.
Error Message QOSMGR-4-POLICER_POLICY_NOT_SUPPORTED: Number of policers has exceeded
per policy hardware limitation for policymap [chars].
Explanation
the hardware. You configured more policers in a policy map (by using the police or police aggregate
policy-map class configuration command) than supported. [chars] is the policy-map name.
Recommended Action
policers.
Error Message QOSMGR-4-QOSLABEL_EXCEED_MAX: Hardware limitation was reached for
policymaps.
Explanation
the hardware, specifically the number of QoS labels. The QoS label entries needed by this particular
policy map configuration, along with the ones already allocated for any other policy maps attached
to interfaces, cause the total number of required entries to exded the limit supported by hardware for
the switch.
Recommended Action
reduce or reconfigure the actions associated with classes to reduce the number of QoS labels.
Error Message QOSMGR-4-QOS_TCAM_RESOURCE_EXCEED_MAX:Exceeded a maximum of QoS TCAM
resources.
Explanation
maximum number of QoS TCAM entries.
Recommended Action
to reduce the number of TCAM entries.
OL-9641-01
"Error Message Traceback Reports" section on page
This message means that the policy-map configuration has exceeded the limitation of
Reconfigure the class maps or the policy maps, or delete the policy map from
This message means that the policy-map configuration has exceeded the limitation of
Reconfigure the class map or the policy map, and reduce the number of
This message means that the policy map configuration has exceeded the limitations of
Reconfigure the class map, reduce number of classes in the policy map, or
The number of QoS TCAM entries required for all attached QoS policies exceeds the
Reconfigure the class map or reduce the number of classes in the policy map
Cisco ME 3400 and 2400 Ethernet Access Switch System Message Guide
QOSMGR Messages
1-4.
2-57
Advertisement
Table of Contents
