Configuring The Conditions For The Fan To Function (Fan Action); Executing Software Reset Of The Repeater (Reset) - Kenwood TKR-D710 Function Reference

3 BASIC OPERATION

3.8 Configuring the Conditions for the Fan to Function (Fan Action)

3.8 Configuring the Conditions for the Fan to Function (Fan Action)
Fan Action is the function which activates the fan equipped on the rear panel of TKR-D710/ TKR-D810 depending
on the status of the repeater.
The following are the fan behaviors that may vary depending on the configuration by using KPG-174D:
Configuration
Continuous
Temperature
Note
The fan cannot be configured to not operate at all.
Configuration using KPG-174D
Configuring Fan Action (
3.9

Executing Software Reset of the Repeater (Reset)

The software reset of the repeater can be done.
Pressing the Reset key or inputting a signal in the AUX Input port to which "Reset" is assigned executes the
software reset, and the repeater is restored to the state just after startup.
(Refer to Available Functions for the AUX Input
Configuration using KPG-174D
Assigning functions to the PF keys on the repeater (
FUNC (E)/Ver 2.50
Table 3-1 Fan Action
Starts the fan spinning when the repeater is turned on and keeps the fan spinning all the time. If the
temperature sensor senses the temperature below zero degrees, the fan stops spinning.
Makes the fan spinning when the temperature inside the repeater rises, and makes the fan stop
spinning when the temperature drops.
Edit > Optional Features > Common Page 1)
See
Ports.)
Description
Edit > Key Assignment)
See
CONTENTS INDEX 12