1 FUNCTIONS AND PANEL LAYOUT
1.4 LED
1.4
LED
The repeater is equipped with the following LEDs which indicate the status of the repeater:
•
TX LED
•
BUSY LED
•
POWER LED
•
Key LED
TX LED
TX LED lights red while the repeater is in the following states:
•
While transmitting
•
While data is being read from the repeater by using KPG-174D
•
Upon completion of writing the firmware
In addition, TX LED flashes red while TX PLL is unlocked.
BUSY LED
BUSY LED lights green while the repeater is in the following status:
•
While the repeater is receiving signals
•
While data is written to the repeater by using KPG-174D
BUSY LED flashes green while the repeater is in the following states:
•
If an error occurs while the firmware is written
•
While RX PLL is unlocked
In addition, BUSY LED flashes orange when a DTMF code that the repeater waits to receive is decoded in PC Test
Mode.
POWER LED
POWER LED lights green while the power source is supplied to the repeater.
Key LED
Key LED is the LED embedded in PF keys. If any PF key is pressed, the Key LED lights red and the function
assigned to the key is activated or enabled. Depending on the function assigned to the PF key, each press of the PF
key may toggle the Key LED between on and off, or the Key LED may light only while the PF key is pressed and
held.
FUNC (E)/Ver 2.50
CONTENTS
INDEX
5