Sharp AR-C360P Color Manual page 93

3
3-93 Using Spot-On
For best results, download and save any measurement data you
have gathered with the ED-100 or ES-1000 in its offline state.
Spot-On automatically clears stored data when it establishes a
connection with the instrument. For information on downloading
stored data from the ED-100 or ES-1000, see the documentation
included with the instrument.
To import color measurements into Spot-On
1. Install and set up the ES-1000 or ED-100 for use with your
computer.
For installation and setup instructions, see the documentation that
came with the instrument.
2. Choose Start from the Instrument menu.
The Choose Port dialog box appears.
3. For Instrument, choose the instrument you will use to take
measurements. For Port, choose the serial port connection of the
instrument. Click OK.
The indicator light on the instrument flashes for a few moments as
the connection to Spot-On is established. When the flashing stops,
the instrument is ready to read measurements.
4. Place the ED-100 or ES-1000 over the target color, making sure to
center the sample aperture over the color. Press Measure to take
the measurement.
The measured CMYK values are imported into Spot-On as follows:
• If an individual color is selected in the color list, it updates to the
measured color.
• If a group is selected in the color list, a new color with the
measured values is created within the group.
• If the Spot-On Color Search window is open, the center patch
updates with the measured values, and the neighbor patches
update accordingly.
Sharp AR-C360P EFI Color Guide - 93