Browser Http Interface - Cisco Aironet 1130AG Series Hardware Installation Manual

OL-8369-04 OL-8369-04
Reloading the Access Point Image Reloading the Access Point Image
St Step ep 9 9
St Step ep 10 10
Web Brow Web Browser ser Inter

Browser HTTP Interface

Browser HTTP Interface
St Step ep 1 1
St Step ep 2 2
St Step ep 3 3
St Step ep 4 4
St Step ep 5 5
St Step ep 6 6
St Step ep 7 7
Hold the MODE Hold the MODE button until the Radio LED turns a red color (approximately 20 to 30 seconds), and button until the Radio LED turns a red color (approximately 20 to 30 seconds), and
release the MODE release the MODE button. button.
After the access point reboots, you must reconfigure the access point by using the Web interface, the After the access point reboots, you must reconfigure the access point by using the Web interface, the
Telnet interface, or Cisco IOS commands. Telnet interface, or Cisco IOS commands.
Interface face
You can also use the Web browser interface to reload the access point image file. The Web browser You can also use the Web browser interface to reload the access point image file. The Web browser
interface supports loading the image file using HTTP or TFTP interfaces. interface supports loading the image file using HTTP or TFTP interfaces.
Note Note Your access point configuration is not changed when using the browser to reload the image file. Your access point configuration is not changed when using the browser to reload the image file.
The HTTP interface enables you to browse to the access point image file on your PC and download the The HTTP interface enables you to browse to the access point image file on your PC and download the
image to the access point. Follow these instructions to use the HTTP interface: image to the access point. Follow these instructions to use the HTTP interface:
Open your Internet browser. Open your Internet browser.
Note Note
The access point web-browser interface is fully compatible with Microsoft Internet Explorer The access point web-browser interface is fully compatible with Microsoft Internet Explorer
version 6.0 on Windows 98 and 2000 platforms and with Netscape version 7.0 on Windows 98, version 6.0 on Windows 98 and 2000 platforms and with Netscape version 7.0 on Windows 98,
Windows 2000, and Solaris platforms. Windows 2000, and Solaris platforms.
Note Note When using the access point browser interface, you should disable your browser pop-up blocker. When using the access point browser interface, you should disable your browser pop-up blocker.
Enter the access point's IP address in the browser address line and press Enter the access point's IP address in the browser address line and press Enter
Password screen appears. Password screen appears.
Enter your username in the User Name field. Enter your username in the User Name field.
Enter the access point password in the Password field and press Enter Enter the access point password in the Password field and press
appears. appears.
Click the Click the System Software System Software tab and then click tab and then click Software Upgrade
Click the Click the Browse Browse button to locate the access point image file (such as c1130-k9w7-tar.123-8.JA.tar) button to locate the access point image file (such as c1130-k9w7-tar.123-8.JA.tar)
your PC. your PC.
Click Click Upload Upload. .
For additional information, click the For additional information, click the Help
Cisco Aironet 1130AG Series Access Point Hardware Installation Guide Cisco Aironet 1130AG Series Access
Chapter 3 3 Chapter
Enter. The Summary Status page
Software Upgrade. The HTTP Upgrade screen appears.
Help icon on the Software Upgrade screen. icon on the Software Upgrade screen.
Point Hardware Installation Guide
Troubleshooting Autonomous Troubleshooting Autonomous Access Access Points
Enter. An Enter Network . An Enter Network
. The Summary Status page
. The HTTP Upgrade screen appears.
3-17 3-17
Points
on on