Cisco Aironet 1130AG Series Hardware Installation Manual page 119

Cisco Aironet 1130AG Series Access Point Cisco Aironet 1130AG Series Access Point Hardware Installation Guide
F-2 F-2
Appendix F F Appendix Priming Lightweigh Priming
St Step ep 6 6
St Step ep 7 7
St Step ep 8 8
St Step ep 9 9
St Step ep 10 10
St Step ep 11 11
Hardware Installation Guide
Lightweight t Access Access Points Points Prior Prior to to Deployment Deployment
If the operating system download is successful, the lightweight access point reboots. Normal operation If the operating system download is successful, the lightweight access point reboots. Normal operation
is indicated when the radio LED is blinking to indicate radio activity. is indicated when the radio LED is blinking to indicate radio activity.
Use controller CLI, controller GUI, or Cisco WCS to configure the lightweight access point with Use controller CLI, controller GUI, or Cisco WCS to configure the lightweight access point with
primary, secondary, and tertiary controller names. primary, secondary, and tertiary controller names.
If the lightweight access point is in a Controller Mobility Group, use the controller CLI, controller GUI, If the lightweight access point is in a Controller Mobility Group, use the controller CLI, controller GUI,
or Cisco WCS to configure the Controller Mobility Group name. or Cisco WCS to configure the Controller Mobility Group name.
Use controller CLI, controller GUI, or Cisco WCS to configure the access point-specific 802.11a, Use controller CLI, controller GUI, or Cisco WCS to configure the access point-specific 802.11a,
802.11b, and 802.11g network settings. 802.11b, and 802.11g network settings.
If the configuration priming was successful, the radio LED is blinking to indicate normal operation. If the configuration priming was successful, the radio LED is blinking to indicate normal operation.
Repeat Steps 4 to 9 for each access point. Repeat Steps 4 to 9 for each access point.
When you successfully complete the configuration priming of all your lightweight access points, ensure When you successfully complete the configuration priming of all your lightweight access points, ensure
Master setting is disabled on your controller. You can begin deploying the access points to their final Master setting is disabled on your controller. You can begin deploying the access points to their final
destinations. destinations.
OL-8369-04 OL-8369-04