Cisco Aironet 1130AG Series Hardware Installation Manual page 46

OL-8369-04 OL-8369-04
Mounting the Access Point Above a Suspended Ceiling Mounting the Access Point Above a Suspended Ceiling
St Step ep 1 1
St Step ep 2 2
St Step ep 3 3
St Step ep 4 4
St Step ep 5 5
St Step ep 6 6
St Step ep 7 7
Cisco Aironet 1130AG Series Access Point Cisco Aironet 1130AG Series Access Point Hardware Installation Guide
Follow these steps to mount the access point above a suspended ceiling. Refer to Fi Figur Follow these steps to mount the access point above a suspended ceiling. Refer to
proceeding. proceeding.
Figur Fig ure e 2-8 2-8 T T -Ba -Bar Gr r Grid M id Moun ountin
6 6
1 1
Suspended ceiling T T -rail Suspended ceiling -rail
2 2
T T -bar box h -bar box h anger anger
3 3
Bracket mounting clip Bracket mounting clip
Insert the bracket mounting clip's tab into the rectangular hole on the access point mounting bracket. Insert the bracket mounting clip's tab into the rectangular hole on the access point mounting bracket.
Place the clip over the T-bar box hanger (refer to Fi Figur Place the clip over the T-bar box hanger (refer to
bracket with the 1/4-20 fastener (supplied with the T-bar hanger). bracket with the 1/4-20 fastener (supplied with the T-bar hanger).
Fig Figur ure e 2-9 2-9 T T -Ba -Bar r and and Mou Mounti
Remove a ceiling tile adjacent to the mounting location. Remove a ceiling tile adjacent to the mounting location.
Configure the ends of the T-bar box hanger to allow for maximum clearance above the ceiling tile. See Configure the ends of the T-bar box hanger to allow for maximum clearance above the ceiling tile. See
the illustration above. the illustration above.
Open the access point cover and connect the Ethernet cable to the access point (see the "Connecting to Open the access point cover and connect the Ethernet cable to the access point (see the
an Ethernet an Ethernet Networ Network with an Inline Power Source k with an Inline Power
Attach the access point to the access point mounting bracket (see the Attach the access point to the access point mounting bracket (see the "
Mountin Mounting Plate" sect g Plate" section on page ion on page
Attach the T-rail clips on the each end Attach the T-rail clips on the each end of the T-bar box hanger to the ceiling
clips are securely attached to the T-rails. clips are securely attached to the T-rails.
Hardware Installation Guide
ting Br g Brac acke ket Pa t Parts rts
1 1 3 3
4 4
5 5
4 4
Access point mounting bracket Access point mounting bracket
5 5
Access point Access point
6 6
T-rail clip T-rail clip
gure e
nting ng Bra Brack cket et
Source" section on page " section on page
2-17 2-17). ).
of the T-bar box hanger to the ceiling grid T-rails. Make sure the
Chapter 2 2 Chapter Installing Installing the
gure
6 6
2 2
2-9 2-9) and secure it to the access point mounting ) and secure it to the access point mounting
2-23 2-23). ).
" Attaching the Acces Attaching the Acces
grid T-rails. Make sure the
2-15 2-15
the Access Access Point Point
e 2-8 before 2-8 before
1 1
8 8
3 3
8 8
1 1
2 2
1 1
9 9
3 3
8 8
1 1
2 2
1 1
"Connecting to
s Point to the s Point to the