Offline Parameterization - Honeywell enCore Series Manual

8
8.3.1

Offline parameterization

There are two alternatives available:
change an existing device parameterization
l
create a new device parameterization
l
Original content will be lost by changing
Do not use any parameter sets stored in the archive or as a backup to
make changes. Instead, always read a new parameter set.
Read-out parameterization
➪
Saving, and exporting the parameter set
➪
Requirements:
The parameter file is opened and shown in the parameterization window.
l
Restrictions of the user management and SSW position allow the transfer of
l
the changed parameters
Offline parameterization takes place in the following steps:
Step Content/Action
Edit the device parameterization.
If you are using a new parameter set or a product parameter set from other devices, please
1.
consider that this is only a template and that all the relevant parameters must be adjusted
on the device before the parameter set is transferred to the device in step 3.
If you fail to do this, the device may react in an undesirable manner.
2. Save the device parameterization .
3. Transfer the changed parameter set to the device with the matching serial number.
Save offline parameterization
Only saved device parameterizations can be transferred, and only to
the device with the matching serial number.
When all the required changes have been made, save the parameterization
After it has been saved, the symbol
in black.
Transfer offline parameterization
1. Establish the data connection to the appropriate device
connection to the measuring device
2. Make sure that there are no other enSutie connections to this device.
3. Highlight the desired device parameterization in the data structure of the nav-
igation window
GasLab Q2
Configuration and analysis software enSuite
(p. 182)
(p. 185)
8.3.3 Editing parameterizations
➪
will turn gray and the lines will be displayed
(p. 176)
User Manual (N )
(p. 234)
.
8.1.2 Data
➪
230 of 315