Set Up - RIDGID SeekTech SR-60 Operator's Manual

SeekTech SR-60

Set up

Once the SR-60 is up and running, the next step is to set up the
frequencies needed to match the transmitter frequency being
used, or the frequency of the line to be located. Each frequency
is selected for use by choosing it from a list in the Main Menu.
If the box on the Main Menu for that frequency is checked, the
frequency is "Checked-Active".
Checked-Active frequencies are already selected for use and ap-
pear in sequence when pressing the Frequency Key
ample, the line trace frequency of 33 kHz is available by pressing
the Frequency Key and advancing through the list until 33 kHz
is reached.)
Note: When a frequency is highlighted in the Main Menu,
pressing the Frequency Key will display its exact frequency
value. For example, 8 kHz = 8192 Hz.
A long press on the Frequency Key
list of all Checked Active frequencies.
Figure 11: Frequency Key
Figure 12: Line Trace Frequency Selected with
Frequency Key
Activating Frequencies
Frequencies can be chosen for the set of Checked-Active fre-
quencies so they will become available using the Frequency Key
Frequencies can also be deactivated to keep the frequency
set smaller.
12
. (For ex-
will bring up a scrollable
Ridge Tool Company
Each frequency is activated by choosing it from a list in the Main
Menu (See figure 14). Frequencies are grouped by category:
SimulTrace (512 Hz + 33 kHz)
Sonde
Active Line Trace
Power (Passive Line Trace)
Radio
OmniSeek (multi-RF bands)
1. Push the Menu Key :
Figure 13: Menu Key
The Main Menu screen is then activated:
Figure 14: Main Menu
2. Using the Up and Down Keys, highlight the frequency
desired (Figure 15). In this example, the operator is activat-
ing the 8 kHz frequency.
Figure 15: Highlighting a Desired
Frequency (8 kHz)
(if active)