Set Up And Operation Seesnake Cable Countir Standard Key Pad Usage; Key Pad Usage In Edit Mode; Edit Menu Fields For Display And System Settings; Battery Removal/Installation - RIDGID Color SeeSnake KD-200 Color Operator's Manual

Kollmann
Figure 11 – Color Monitor +
The sunshade on this Color Monitor
locked open, and the tilt stand is engaged. Close the
sun shade whenever the Monitor
Always adjust the settings below for each inspection
to ensure the optimum picture.
Set Up and Operation
SeeSnake Cable CountIR Standard Key
Pad Usage
Distance Zero
Distance: Displays distance reading in lower right
hand corner of screen. To remove distance
reading press once, press again to show
distance reading.
Zero: Resets distance reading to zero.
8
SeeSnake ™ Diagnostic Equipment
VCR Front
VCR has been
+
+ VCR is not in use.
Clock
Ridge Tool Company • Elyria, Ohio • U.S.A.
Clock: Displays date and time. Press to choose
both, one, or none displayed. Press and
hold to display optional title field (see
description of title field below).

Key Pad Usage in Edit Mode

Press Distance and Clock simultaneously to get into
edit mode.
Distance: Functions as edit button. Press to cycle
through available options.
Zero: Functions as next button. Press to move to
next field.
Clock: Functions as exit button. Press to exit from
edit mode, saving any changes made.
Edit Menu Fields for Display and
System Settings
Time: Display choice...12 hr (AM/PM) or 24 hr
Date: Display choice...mm/dd/yy or dd/mm/yy
Units: Display choice...feet (ft) or meters (m)
Title: The title field is factory set to read
RIDGID/Kollmann, but can be changed to
display your company name or any
desired message of up to 18 characters.
(The edit button will scroll through optional
letters and symbols while the next button
will take you to the next title space until
you are through the 18 character field.)
Press Distance and Clock at same time to edit
SeeSnake type and cable length.
Cable Select the actual push cable length for
Length: your SeeSnake. The selection for length in
feet is from 50 to 325 in 5 foot increments.
The selection for length in meters is from
15 to 100 in 1 meter increments.
SeeSnake Select type of SeeSnake System, either
System: Mini or Standard.

Battery Removal/Installation

1. The CountIR uses a single Lithium CR-2032, 3 Volt
battery to maintain the memory of the Edit Con-
figuration and also to power the clock module dur-
ing system power down.
2. The battery is located inside the CountIR just below
the cabling connector. It is easily removed by using
a thumbnail or a small pair of needle nose pliers.
3. When the battery is removed all of the Edit Menu
Fields and System Settings are lost and will need