Procedures Before Operation - Mitsubishi Electric NZ2FTGN User Manual

11.5

Procedures Before Operation

1.
Installation
Attach the NZ2FT system to the DIN rail and install it in a suitable environment. ( Page 36 Installation Environment and
Installation Position of Module, Page 38 Installation)
2.
Wiring
Connect the power cable and Ethernet cable to the NZ2FT-MT. ( Page 45 Wiring of power cable and I/O cable,  Page
41 Wiring products for coupler that use the Ethernet cable)
Connect the I/O cables to the I/O module. ( Page 45 Wiring of power cable and I/O cable)
3.
DHCP/BootP server setting
To use DHCP or BootP, set the DHCP server or BootP server in advance.
Use the static IP address. For the server setting, refer to the manual of the server used.
4.
Master device settings
Check the firmware and software package version of the corresponding master module. ( Page 263 Corresponding
master module and software package)
Set the parameters with the software package according to the master module to be used.
• Page 299 Settings on the master station (RJ71EN71)
• Page 302 Settings on the master station (QJ71MT91)
5.
Connection between the Web server and personal computer
Access the NZ2FT-MT Web server via the USB port or the Ethernet port. ( Page 60 Connection with a Personal
Computer)
6.
Slave device settings
Set the parameters of the NZ2FT-MT and I/O module on the Web server. ( Page 304 Parameter list)
11 NZ2FT-MT
298
11.5 Procedures Before Operation