NETGEAR ProSafe WFS709TP Software Administration Manual page 35

Table 1-3 describes the Basic Configuration pages in the browser interface.
Table 1-3. Configuration Pages (Basic)
Page
WLAN
Security
Network
Management
Access Point Installation
Wizard
The following buttons are available on both the Basic and Advanced Configuration pages:
• Apply. Accepts all configuration changes made on the current page.
• Save Configuration (appears in top right corner of the browser interface when the
Configuration tool is selected). Saves all applied configuration changes made during the
current configuration session. Saved settings are retained when the WFS709TP is rebooted or
powered off while unsaved configuration changes are lost.
• Clear. Resets options on current page to the last-applied or saved settings.
• Add. Adds a new item to the current page. Typically a set of relevant configuration fields for
the item to be added is displayed.
• Edit. Allows you to edit the configuration of the selected item.
• Delete. Removes the selected item from the page configuration.
Note: By default, clicking Apply does not save the configuration. Once you finish
configuring the switch, always remember to click Save Configuration.
Overview of the WFS709TP
WFS709TP ProSafe Smart Wireless Switch Software Administration Manual
Description
These pages allow you to configure an SSID and related WLAN options.
These pages allow you to configure the security Profile for Rogue AP detection.
These pages allow you to configure ports, VLANs, IP interfaces, and DHCP-
related information.
These pages allow you to configure the system clock, SNMP-related
information, and management access.
This page allows you to discover and configure Light Access Points connected
to the Switch.
v1.0, June 2007
1-19