NETGEAR ProSafe WFS709TP Software Administration Manual page 120

WFS709TP ProSafe Smart Wireless Switch Software Administration Manual
Table 6-1. RADIUS Server Configuration Information
Parameter
Num Retries
Timeout
NAS Source IP Address
NAS Identifier
Match ESSID
Match FQDN
Trim FQDN
Mode
2. Navigate to the Configuration > Advanced > Security > AAA Servers > RADIUS Servers
page.
3. Click Add to add a new RADIUS server entry. Enter the values you gathered into the fields
shown in Figure 6-1.
Figure 6-1
6-2
Description
Maximum number of retries sent to the server by the WFS709TP
before the server is marked as down (default is 3)
Maximum time, in seconds, that the WFS709TP waits before timing out
the request and resending it (default is 5 seconds
Network Access Server (NAS) IP address to send in RADIUS packets.
NAS identifier to use in RADIUS packets.
Match the ESSID for the user name
Match the fully qualified domain name (FQDN) in the user name
Trim the FQDN from the user name before sending to the RADIUS
server
Enables or disables the server
v1.0, June 2007
Configuring AAA Servers