NETGEAR ProSafe WFS709TP Software Administration Manual page 104

WFS709TP ProSafe Smart Wireless Switch Software Administration Manual
• Shared Key: radius123
The administrator for the RADIUS server must configure the server to support authentication. The
administrator must also configure the server to allow communication with the WFS709TP.
To configure the WLAN in the WLAN Basic Configuration page:
1. Navigate to the Configuration > Basic > WLAN page. Enter corpnet for Network Name
(SSID).
2. Select 802.11 b/g for Radio Type.
3. Select WPA for Network Authentication
TKIP is automatically selected for the encryption and Auth Server Type is activated with
RADIUS selected.
4. Under Authentication Server, click Add.
5. Under Choose an Authentication Server, select NEW and click Add.
a. Enter Radius01 for Server Name.
b. Enter 10.3.22.253 for IP Address.
c. Enter radius123 for Shared Key.
d. Click Add. The server information appears under Authentication Server.
6. Enter 10 for VLAN ID.
The page should look like
5-8
Figure 5-2.
v1.0, June 2007
Configuring WLANS