Configuring Radio Settings - NETGEAR ProSafe WFS709TP Software Administration Manual

WFS709TP ProSafe Smart Wireless Switch Software Administration Manual
• Power Management. Enables power management.
• Bootstrap Threshold. Number of heartbeat misses before an AP reboots.
• VoIP CAC Disconnect Extra Call. Enables disconnecting of calls that exceed the high
capacity threshold.
• RF Band. RF band in which the AP should operate: g = 2.4 GHz, a=5GHz.

Configuring Radio Settings

You can fine-tune radio settings on a per-radio (802.11a or 802.11b/g) basis.
Note: Selecting these options may affect roaming performance.
To configure radio settings that affect all APs in the network, navigate to the Configuration >
Advanced > WLAN > Network > Radio page.
To configure radio settings for APs in a specific location in the network:
1. Navigate to the Configuration > Advanced > WLAN > Advanced page.
2. Click Add to add a new location.
3. Enter a location ID in the format building.floor.plan, where each value is an integer.
4. Click Add.
5. Select the 802.11b/g or 802.11a tab to configure radio settings
5-14
v1.0, June 2007
(Figure 5-5).
Configuring WLANS