Configuring User Accounts Settings - Honeywell 35 Series User Manual

Export Configuration File
Click EXPORT to export all parameters for the camera and user-defined scripts.
User needs to specify the password before exporting the configuration file.
Note:
Upload Configuration File
Follow the steps below to upload a configuration file:
1. Enter the password for uploading the configuration file. The password must be the
same with the password of the configuration file you set for exporting, or the
uploading will be failed. For example, if you set the password A for the
configuration file A and you set the password B for the configuration file B. When
you want to upload the configuration file B, you must use the password B.
2. Click CHOOSE FILE to locate the configuration file and then click UPLOAD to
upload the configuration file.
The model and firmware version of the device should be the same as the configuration
file. If you have set up a fixed IP or other special settings for your device, it is not
suggested to update a configuration file.
If the power is disconnected during firmware upgrade or if there is unknown reason
causing abnormal LED status, and a Restore cannot recover normal working condition,
you can perform the following steps to activate the camera with its backup firmware:
a) Press and hold down the reset button for at least one minute.
b) Power on the camera until the Red LED blinks rapidly.
c) After boot up, the firmware should return to the previous version before the

Configuring User Accounts Settings

Go to Setup > System Setup > User Accounts.
This section describes how to create multiple accounts and grant privileges to these
accounts.
56
camera hanged. (The procedure should take 5 to 10 minutes, longer than the
normal boot-up process). When this process is completed, the LED status
should return to normal.
Honeywell 35 Series IP Cameras User Guide