Table of Contents
Advertisement
CHAPTER
1
A
This guide contains planning, installation and service information for the Honeywell-configured HP
Proliant DL360p Generation 8 (Gen8) server. The instructions and service information contained in this
guide addresses the server, and assumes that associated network communication equipment is pre-
installed by the Honeywell factory or has manuals dedicated to its installation and service. This server
is not a standard HP model and you cannot order it independently from HP.
NOTE
If the Local Control Network (LCN) coaxial based system has been integrated with an Experion
Fault Tolerant Ethernet (FTE) based system, the node (server) may be upgraded to be an
Experion Local Control Network (ELCN) node, which has its ELCN Interface provided via FTE.
This node may be installed as a physical or virtual platform.
If the node is upgraded to an ELCN node, and the node is a physical (a.k.a. bare-metal)
platform, a Local Control Network Processor (LCNP) board coaxial interface to LCN is not used.
The LCN MAU is disconnected, and/or the LCNP board is removed.
Redundant ELCN Bridges are required if the ELCN node is communicating with any other
existing, coaxial-based LCN node.
Some LCN nodes may have been replaced by their ELCN equivalent nodes, and overall system
features/architecture will differ from that of a non-ELCN integrated system (classic LCN/TPN
system). In this case it may be necessary to refer to appropriate ELCN documentation, in
addition to the information provided herein.
The following table lists Honeywell ELCN/Experion publications that may be useful for references.
ELCN Reference Documents Table for Server/Workstation PSIG Documents
D
BOUT THIS
OCUMENT
- 6 -
Advertisement
Table of Contents
