Removing The Old Power Supply - Cisco AS5350XM Installation Manual

Removing the Old Power Supply

Figure B-8
Power
supply
Disconnect both power supply connectors. Disconnect the backplane connector first, followed by the
Step 5
system board connector. (See
Note
Figure B-9
Power
supply
Front panel
Slide the power supply toward the front panel to disengage the power supply from the chassis hooks.
Step 6
(See Figure
Cisco AS5350XM Universal Gateway Chassis Installation Guide
B-8
Power Supply Connectors
Figure
The system board connector is located on the system board, below and to the left of the
backplane connector.
Disconnecting the Power Connectors from the Backplane
3
Power connector
Backplane
B-10.) Remove the power supply from the chassis.
Backplane
connector
System board
connector
B-9.)
Chassis bottom
Appendix B Replacing the Power Supply
OL-6417-02