Cisco AS5350XM Installation Manual page 82

Replacing the Chassis Cover
Figure B-14
Lower the front of the top cover to close the chassis, and ensure the following:
Step 3
The chassis cover tabs fit under the edge of the chassis rear panel so that they are not exposed.
•
The chassis tabs fit under the chassis cover so that they are not exposed.
•
The chassis cover side tabs on both sides fit inside the chassis side panels so that they are not
•
exposed.
When the chassis cover is properly assembled, no tabs are visible.
Step 4 Secure the chassis cover with five screws.
Step 5 If you installed a different type of power supply (AC or DC) than was originally installed in the universal
gateway, place one of the power ratings labels that came in the plastic bag with the documentation
directly over the power ratings information on the rear panel. For example, if the original chassis came
with an AC power supply and you replaced it with a DC power supply, place the DC power ratings label
over the ratings stamped on the rear panel of the chassis. This will ensure that the correct power ratings
information appears on the rear panel. (See
Figure B-15
INPUT -48/-60V ==
Figure B-16
INPUT 100 – 240V~ 50/60Hz
Figure B-17
Reinstall the chassis on a rack, desktop, or table.
Step 6
Reinstall all interface cables.
Step 7
Cisco AS5350XM Universal Gateway Chassis Installation Guide
B-12
Replacing the Chassis Cover
Chassis cover
3
Front panel
Power Ratings Label for DC Power Supply
3A 150VA
Power Ratings Label for AC Power Supply
Chassis bottom
Figure B-15 and
2 – 1A
Appendix B Replacing the Power Supply
Figure B-16.)
OL-6417-02