Displaying The Environment Status - Cisco AS5350XM Installation Manual

Chapter 4 Troubleshooting
Figure 4-2
•

Displaying the Environment Status

You can use the command-line interface (CLI) to check environment monitoring status of the
Cisco AS5350XM universal gateway.
To check environment monitoring, enter the show environment command in privileged EXEC mode, as
follows:
Router# show environment
•
•
OL-6417-02
Cisco AS5350XM Universal Gateway Slot Numbering
Slot 0
Slot 2
This process is repeated at 10-minute intervals until the final DFC is shut down. The console
displays the slot number of the DFC and the type of DFC that was shut down.
If the operating temperature cools down to 45°C (104°F), Cisco IOS software powers on the first
DFC, repeating the process for each DFC at 10 minute intervals.
When the operating temperature of the system rises above 65°C, Cisco IOS software shuts down all
DFCs immediately.
The display shown below appears on your console during normal operating conditions. The slot
number corresponds to the DFC in that slot. The outlet and inlet sensors read the temperature of the
air circulating inside the chassis.
Router# show environment
Temperature:
Temperature Reading:
Temperature at inlet is measured as 22C/71F.
Temperature at outlet is measured as 27C/80F.
Temperature State:
Temperature is in normal state.
Fans:
Fans temperature delta is measured as 5C.
All fans are running well.
Power Supply:
Redundant Power System is present.
The display below appears on your console when the system reaches a warning state:
Router# show environment
Temperature:
Temperature Reading:
Temperature at inlet is measured as 52C/125F.
Temperature at outlet is measured as 64C/147F.
Temperature State:
Temperature is in warning state.
Fans:
Fans temperature delta is measured as 6C.
All fans are running well.
Power Supply:
Redundant Power System is present.
RPS Input Voltage status: normal
Slot 1
Slot 3
Cisco AS5350XM Universal Gateway Chassis Installation Guide
Monitoring the Environment
4-3