Cisco AS5350XM Installation Manual page 37

Chapter 3 Installing the Cisco AS5350XM Universal Gateway
Installing in a Rack
Do not use the handles on the dial feature cards to assist in lifting the chassis.
Caution
To install the chassis into the equipment rack, follow this procedure:
With the mounting brackets attached to the chassis, support the chassis and align the holes in the brackets
Step 1
with the screw holes in the rack. (See
Attach the chassis to the rack with the screws you have provided. (See
Step 2
Figure 3-4
Note: The second bracket attaches to the rack at the other side
Connecting the Chassis Ground
You must connect the chassis to a reliable earth ground using the ground lug (provided) and size AWG 6
(13 mm
To attach the chassis ground, take the following steps:
Strip one end of the ground wire to expose approximately 0.75 in. (20 mm) of conductor.
Step 1
Crimp the ground wire to the ground lug, using a crimp tool of the appropriate size.
Step 2
Attach the ground lug to the chassis. (See
Step 3
screws supplied with the ground lug. Tighten the screws to a torque of 8 to 10 in-lb (0.9 to 1.1 N-m).
Connect the other end of the ground wire to a suitable grounding point at your site.
Step 4
OL-6417-02
Attaching the Chassis to a 19-Inch Rack—Rear Panel Forward
of the chassis. The chassis can also be installed with the
front panel forward.
2
) wire.
Figure 3-4.)
Figure 3-5.) Use a medium flat-blade screwdriver and the
Cisco AS5350XM Universal Gateway Chassis Installation Guide
Setting Up the Chassis
Figure 3-4.)
3-5