Wiring The Dc Power Supply - Cisco AS5350XM Installation Manual

Chapter 3 Installing the Cisco AS5350XM Universal Gateway
Figure 3-16
Figure 3-17
Step 3
Power up the universal gateway.
Step 4
The internal power supply fan should power up.

Wiring the DC Power Supply

If you ordered the Cisco AS5350XM universal gateway with a DC power supply, follow the procedure
in this section to wire the terminal block.
The grounding architecture for the Cisco AS5350XM universal gateway is isolated DC return (DC-I).
Note
Before performing any of the following procedures, ensure that power is removed from the DC circuit.
Warning
Statement 1003
Warning Before connecting or disconnecting ground or power wires to the chassis, ensure that power is
removed from the DC circuit. To ensure that all power is OFF, locate the circuit breaker on the panel
board that services the DC circuit, switch the circuit breaker to the OFF position, and tape the switch
handle of the circuit breaker in the OFF position. Statement 140
OL-6417-02
Connecting the AC Power Cord
Connecting the AC Power Cord to the Redundant Power Supply
Cisco AS5350XM Universal Gateway Chassis Installation Guide
Supplying Power
Power switch
Power cables
3-15