Table of Contents
Advertisement
3G Router
5.2.3. 3G Configuration
Network mode:You can configure the network selection in: Automatically, GSM only, 3G Only or 3G preferred.
Define the connection mode:
• Always on: 3G Router will enable 3G connection at power on. If some disconnections should occur, the Gateway will try to
restore them automatically.
• Manually: In this mode the user manually decides when the connection must be enabled and for how long.To enable (connect)
and disable (disconnect) 3G connection, use the push buttons in the Home page. With manually connection you can configure
the remote activation with SMS or CLI.
SMS service center:
APN, Username e Password: These information depend on operator that must supply them.
PIN:
Idle Timeout:
5.2.3.1. Remote Activation
To enable Remote Activation (RA) it is necessary to activate the functionality and set the options in 3G UMTS menu.
Code:
Anyone:
Phone Num:
Delete all SMS:
Disconnect Timeout:
5.14
Number of SMS service center
If the SIM you are using requires the PIN, you must insert it in this field.
not supported, for future application.
4 digits code set by user.
If ON any mobile phone can enable the remote connection with an SMS.
This allows the restriction of enabling remote connection to one number only.
The number must be inserted with the international prefix (i.e..+393351234567). Only the number inserted
in Phone Num will be able to activate the remote connection (Anyone option disabled).
If enabled, it activates the cancellation of all SMS received after the reception of an SMS concerning
the RA application (connection, disconnection and reset). This option is useful in installations without
operator to avoid the SIM fills with SMS, blocking the operation of Remote Activation.
It defines the period of connection (default 600 seconds). After the disconnect timeout the connection is
Configuration
Advertisement
Table of Contents
