Pin And Puk Management - Digicom 3G Corporate DG 11 User Manual

3G Router

2.2. PIN AND PUK MANAGEMENT

The PIN request is always enabled on the SIMs; to use them inside 3G Router you can:
1. Disable the PIN request on the SIM (through a cellular phone).
2. Insert the PIN in the 3G Router configuration. At power on, the device will send the PIN to the SIM.
3G Router will show the PIN request from the SIM through the fast blinking of 3G led (red).
You can setup 3G Router in two ways:
A. WEB based configuration (3G Umts menu). Click Save&Reboot to enable the configuration.
B. Through the phone keyboard (set the DTMF selection) connected to TEL1 or TEL2 connector (available in the version with
TEL-FXS port only).
Lift the receiver, you will hear the tone of PIN code request (two close beeps repeated with a pause).
1. Digit the PIN code using the phone keyboard and confirm by pressing "#" (set on the phone the DTMF selection) PIN# code
(i.e.0123#)
2. To cancel the PIN code insertion, hang up before you confirm the PIN code with "#".
3. If the PIN code is correct, you will hear the correct configuration tone (two tones repeated), or the tone for wrong PIN (three
tones repeated).
4. Hang up to complete the procedure. Now 3G Router will automatically save the PIN in the configuration and it will make a
Reset.
5. At 3G Router start up, the PIN is no more asked for and the SIM will register to the network.
PUK management
The PUK code can be inserted with the same procedure as for the PIN insertion, through the phone keyboard (available in the
version with TEL-FXS port only) or by inserting the SIM inside a mobile phone.
ATTENTION: the PIN and PUK codes are indicated on the PIN-PUK card supplied by the Telecom Operator
when you buy the SIM card. If a wrong PIN number is inserted for 3 times, it will be necessary to insert the
PUK code followed by a new PIN code. After 10 wrong PUK codes, the SIM card will be blocked permanently
and you have to substitute it.
2.4
Hardware Installation