Quick Configuration; Phone Call; Data Call - Digicom 3G Corporate DG 11 User Manual

3G Router

3.1. QUICK CONFIGURATION

This paragraph describes the main parameters to be set to make and receive calls (if the FXS "TEL" interface is supported) and
to start the Internet surfing in 3G mode.

3.1.1. Phone Call

For FxS interface versions only.
To start making/receiving calls you must have followed the instructions of the Hardware Installation chapter:
• Connect the GSM antenna
• Insert the SIM (we recommend to disable the PIN)
• Connect a phone to the connector Tel 1
• Connect the power supply and turn 3G Router on
• As soon as the 3G led will show the indications of the network, you will be able to make and receive calls.
3.1.2. 3G Data Call
To make a call in 3G mode, check that the WAN is set to 3G (Configuration menu, WAN, WAN configuration).
• In the 3G UMTS menu insert the information (depending on the GSM operator you are using) for APN, Username and Password
(for some operators the APN is sufficient).
• Define the connection mode:
Always on:
Manually:
Note: Verify with your telecom operator the profile of the SIM you are using for the Internet connection.
3.2
3G Router will enable 3G connection at power on. If some disconnections should occur, the Gateway
will try to restore them automatically.
In this mode the user manually decides when the connection must be enabled and for how long. To enable
(connect) andd disable (disconnect) 3G connection, use the push buttons in the Home page.
WEB Configuration