Casio DT-X200 Service Manual page 45

3. W-LAN
1. Preparation
Connect equipment as follows:
Access Point
2. Operation
No.
"
Select
Panel" -
Check the checkbox "WLAN
Power Enable" and click
"OK" to supply power to the
integrated WLAN module.
1
"
Select
"
Communication" -
Then, input "SSID", "IP
address", etc. of the target
access point.
2
Wireless
Transmission
Operation
"
Settings" - Control
"
WLANPower".
Programs" -
"
NetSearch".
Display
– 42 –
DT-X200/DT-X8
Test Details
The Indicator 2 (on the right side
of DT-X200/DT-X8) starts fl ashing
in orange.
Carry out SS wireless test using
"Ping" and "Signal" functions.
Check if the test results are
acceptable comparing with a good
DT-X200/DT-X8.