Configuring Snmp Settings - Honeywell HRHT4041 User Manual

Configuring SNMP Settings

You can use Simple Network Management Protocol (SNMP) to receive information from the
DVR remotely. You will need to install SNMP software on a PC to receive information from the
DVR via SNMP.
To configure SNMP settings
1. Go to Main Menu  Setting  Network  SNMP.
Figure 9-10
2. On the SNMP page, select the Enable check box to enable SNMP.
3. Configure the following settings:
•
Version
•
SNMP Port
•
Read Community
•
Write Community
•
Trap Address
•
Trap Port
4. If SNMP Version V3 is selected, the following settings are also configurable:
ReadOnly User: The default setting is public.
Read/Write User: The default setting is private.
Authorize Type: Select the authorization type, MD5 or SHA, for both the
ReadOnly and Read/Write users. The default setting is MD5.
Select the check boxes of the SNMP version(s) that
you are using.
The default setting is 161.
The default setting is public.
The default setting is private.
Enter the IP address of the computer running
SNMP software.
The default setting is 162.
Configuring Network Settings
81