Honeywell HRHT4041 User Manual page 138

Performance Series HQA Digital Video Recorder Local User Guide
1. Go to Main Menu  Setting  System  Card Overlay  Net.
Figure 12-11
2. On the Net tab, configure the following settings:
•
Protocol
•
Overlay Mode
•
Preview
•
Record
•
Overlay Position
•
Source IP/Port
•
Destination/Port
•
Record Channel
•
Frame ID
Click Apply, and then click Save to save the settings.
3.
126
Select ATM/POS.
The Preview and Encode overlay modes are
enabled by default. Clear the check boxes if you
want to disable them.
When enabled, text overlay will be visible in the
preview mode.
When enabled, text overlay will be visible in the
recording.
Select Top Left, Bottom Left, Top Right, or Bottom
Right.
Enter the source IP and port. The source IP refers to
the host IP address that sends out the information.
Enter the destination IP and port. The destination
IP refers to the IP address of the device that
receives the information.
Select a camera.
Configure up to 6 Frame IDs to ensure valid and
legal information.
Enter the StartPosition, Length, and Key. Click
Data to enter Start Position, Length, and Title
information for up to four fields, and then click
Save.