Install And Remove Nims And Sm-Xs On Cisco 4000 Series Isrs - Cisco 4000 Series Hardware Installation Manual

Install and Remove NIMs and SM-Xs on Cisco 4000 Series ISRs

Figure 5-25
Replace the chassis cover. See the
Step 8
Install and Remove NIMs and SM-Xs on Cisco 4000 Series ISRs
Network Interface Modules (NIMs), Service Modules (SM-Xs), and Cisco E-Series Server Modules plug
into the various slots on the motherboard. SM-Xs are sold as spare parts with labels that identify the
SM-X type. See the following sections for SM-X installation tasks:
The procedures in this section apply to NIMs, SM-Xs, and Cisco E-Series Server modules.
Note
•
•
•
•
•
Always wear an ESD-preventive wrist strap and ensure that it makes good contact with your skin when
Caution
you remove or install an SM-X. Connect the equipment end of the wrist strap to the metal part of the
chassis.
Handle SM-Xs and NIMs by the edges only. SM-Xs are ESD-sensitive components and can be damaged
Caution
by mishandling.
Hardware Installation Guide for Cisco 4000 Series Integrated Services Routers
5-30
Install a DIMM
Software Requirement for SM-Xs
Locate SM-X or NIM
Remove SM-X or NIM
Install SM-X
Verify SM-X Installation
Chapter 5
"Remove and Replace Chassis Cover" section on page
Install and Upgrade Internal Modules and FRUs
5-4.
OL-32185-02