Prepare For Network Connections; Ethernet Connections; Required Tools And Equipment For Installation And Maintenance - Cisco 4000 Series Hardware Installation Manual

Chapter 2 Cisco 4000 Series ISRs Preinstallation

Prepare for Network Connections

When setting up your router, consider distance limitations and potential electromagnetic interference
(EMI) as defined by the applicable local and international regulations.
Network connection considerations are provided for:
•
See the following online document for more information about network connections and interfaces:
•
To avoid electric shock, do not connect safety extra-low voltage (SELV) circuits to telephone-network
Warning
voltage (TNV) circuits. LAN ports contain SELV circuits, and WAN ports contain TNV circuits. Some
LAN and WAN ports both use RJ-45 connectors. Statement 1021

Ethernet Connections

The IEEE has established the Ethernet IEEE 802.3 Standards. The routers support the following Ethernet
implementations:
•
•
•
•
For information about Ethernet cables, connectors, and pinouts, see the
Cable Specifications

Required Tools and Equipment for Installation and Maintenance

Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Warning
Statement 1030
Warning This equipment must be installed and maintained by service personnel as defined by AS/NZS 3260.
Incorrectly connecting this equipment to a general-purpose outlet could be hazardous. The
telecommunications lines must be disconnected 1) before unplugging the main power connector or 2)
while the housing is open, or both. Statement 1043
OL-32185-02
Ethernet Connections, page 2-13
Cisco Modular Access Router Cable Specifications
1000BASE-T—1000 Mb/s full-duplex transmission over a Category 5 or better unshielded
twisted-pair (UTP) cable. Supports the Ethernet maximum length of 328 feet (100 meters).
100BASE-T—100 Mb/s full-duplex transmission over a Category 5 or better unshielded
twisted-pair (UTP) cable. Supports the Ethernet maximum length of 328 feet (100 meters).
10BASE-T—10 Mb/s full-duplex transmission over a Category 5 or better unshielded twisted-pair
(UTP) cable. Supports the Ethernet maximum length of 328 feet (100 meters).
10GBASE—Cisco 4461 supports 10GE full-duplex.
document.
Hardware Installation Guide for the Cisco 4000 Series Integrated Services Router
Required Tools and Equipment for Installation and Maintenance
Cisco Modular Access Router
2-13