Install Dimm - Cisco 4000 Series Hardware Installation Manual

Install and Remove DDR DIMMs on Cisco 4400 or 4300 Series ISRs
Figure 5-22
Place the DIMM in an antistatic bag to protect it from ESD damage.
Step 5
Replace the chassis cover. See the
Step 6

Install DIMM

The DIMMS on the Cisco 4400 Series ISRand Cisco 4300 Series ISR are not interchangeable.
Note
To install a DIMM:
Read the
Step 1
replace any module.
Remove the chassis cover. For the Cisco 4451-X ISRs, see the
Step 2
section on page
Locate the DIMM module. See the
Step 3
section on page 5-8
Make sure that both latches on the DIMM connector are in the open position.
Step 4
Orient the DIMM so that the polarization notch lines up with the polarization key on the connector. See
Step 5
Figure
Hardware Installation Guide for Cisco 4000 Series Integrated Services Routers
5-28
Remove a DIMM
"Safety Warnings" section on page 5-2
5-4.
to find the DIMM sockets on the router.
5-23.
Chapter 5
"Remove and Replace Chassis Cover" section on page
section and disconnect the power supply before you
"Locate Internal and External Slots for Modules on Cisco 4451 ISR"
Install and Upgrade Internal Modules and FRUs
"Remove and Replace Chassis Cover"
5-4..
OL-32185-02