Install The Ssd Msata Storage Device - Cisco 4000 Series Hardware Installation Manual

Chapter 5 Install and Upgrade Internal Modules and FRUs

Install the SSD mSATA Storage Device

To install a SSD mSATA storage device:
Read the
Step 1
module.
Remove the chassis cover. For instructions on removing the chassis cover, see
Step 2
Chassis Cover" section on page
Place the SSD mSATA storage device on the SSD mSATA connector and align the device's contact edge
Step 3
with the corresponding socket in the connector.
Press the device downward into the connector until it is level with the surface of the connector.
Step 4
While holding the device down, screw the device into place (see
Step 5
Figure 5-55
OL-32185-02
"Safety Warnings" section on page 5-2
5-4.
Flash Memory Card and SSD mSATA Storage Device Locations
Hardware Installation Guide for Cisco 4000 Series Integrated Services Routers
Install and Remove an SSD mSATA Storage Device
and disconnect the power supply before you replace any
Figure 5-55).
1
1
2
3
4
5
6
"Remove and Replace
5-73