Remove The Ssd Msata Storage Device - Cisco 4000 Series Hardware Installation Manual

Install and Remove an SSD mSATA Storage Device
1
3
5
Step 6 Replace the chassis cover. See

Remove the SSD mSATA Storage Device

Read the
Step 1
any module.
Remove the chassis cover. For instructions on removing the chassis cover, see
Step 2
Chassis Cover" section on page
Unscrew the screws that attach the SSD mSATA storage device to the chassis. See
Step 3
The card should popup after the screws are removed.
Step 4
Install a new SSD mSATA memory device if needed. See
Step 5
page
Replace the chassis cover. See
Step 6
Hardware Installation Guide for Cisco 4000 Series Integrated Services Routers
5-74
Supplied screw
Flash memory card
Flash memory card connector
"Safety Warnings" section on page
5-73.
Chapter 5
2
Supplied screw
4 SSD mSATA storage device
6 SSD mSATA connector
"Remove and Replace Chassis Cover" section on page
5-2, and disconnect the power supply before you replace
5-4.
"Remove and Replace Chassis Cover" section on page
Install and Upgrade Internal Modules and FRUs
"Remove and Replace
Figure
Install the SSD mSATA Storage Device,
5-4.
5-54.
5-4.
OL-32185-02