Connecting The Cables - Honeywell MZ-PCSV74 Planning, Installation And Service Manual

Chapter 3 - Installation
3.4.2

Connecting the cables

To connect the cables
1. Connect the video and network interface cables.
2. Connect the Honeywell AC power cords.
3. Perform any one of the following, as necessary.
l
l
l
4. Secure any loose cables, and verify that all cables have proper strain relief.
WARNING
AC power cords from all computing nodes mounted in a given cabinet must be distributed
across the two power entries as equally as possible. Failure to do so may result in tripping
the circuit breakers.
If you are not using Fault Tolerant Ethernet (FTE), connect the Ethernet cable to the on-board
RJ-45 connector.
If you are using an Intel dual NIC card for FTE, connect the FTE cable to the NIC card in the
expansion slot.
If you are using the on-board NICs for FTE, connect the FTE cable to the onboard RJ-45
connector.
- 26 -