Configuring Controlnet Interface Card; Installing Controlnet Card Inside Magma Chassis - Honeywell MZ-PCSV74 Planning, Installation And Service Manual

Chapter 4 - Operation
are used to mark the beginning and end of a trunk segment and Tap Dummy Load (TDL) which
terminate a drop cable when no node is present. The model number for the ControlNet Universal
Interface is TC-PCIC02-100.
The following image displays the PCIC card used by Honeywell.
TC-PCIC02: This is a universal PCIC card.
ATTENTION
TC-PCIC02: Controlnet Network interface can be connected toDell PowerEdge T130
serverusing Magma PCIe to PCI converter. For more information on "How to connect using
Magma Converter", refer to the Magma PE3R Installation Instructions available at the following
Honeywell Process Solutions support website.
https://www.honeywellprocess.com/library/support/Documents/Experion/Magma_Installation_
Instructions_HWDOC-X279-en.pdf
4.3

Configuring ControlNet interface card

You can configure a ControlNet interface card using the Magma PE3R PCie to PCI converter box.
1. For more information on the Magma PE3R PCie to PCI converter box, log into
honeywellprocess.com.
2. Enter your user name and password.
3. Go to the Product Support section.
4. Search for Magma PE3R instructions.

Installing ControlNet card inside Magma chassis

l
4.3.1 Installing ControlNet card inside Magma chassis
Refer to the Magma PE3R Installation Instruction available at the following Honeywell Process
- 31 -