A-6. JK Sheet Assembly
(Time required: About 10 minutes)
A-6-1. Open the control panel U5 assembly and secure with
the service stays. (See procedure 1)
A-6-2. Remove the rear upper U5 sub assembly.
(See procedure A-1)
A-6-3. Remove the four (4) screws marked [960], the two (2)
screws marked [970A], the two (2) hexagonal nuts
marked [N2] and the two (2) screws marked [970B].
The JK sheet assembly can then be removed.
(Photo 12)
A-7. HAAD Circuit Board
(Time required: About 12 minutes)
A-7-1. Open the control panel U5 assembly and secure with
the service stays. (See procedure 1)
A-7-2. Remove the rear upper U5 sub assembly.
(See procedure A-1)
A-7-3. Remove the two (2) screws marked [850]. The FFC
angle FR can then be removed. (Photo 13)
A-7-4. Remove the sixteen (16) screws marked [750] and
the two (2) screws marked [820]. The HAAD circuit
board can then be removed. (Photo 13)
JK SHEET ASSEMBLY
(JK シート Ass y)
[970B]
[960]
[970A]
Photo 12 ( 写真 12)
[970B]
[N2]
[960]
A-6. JK シート Ass y
(所要時間:約 10 分)
A-6-1. コンパネ U5 Ass y を開けて、サービスステイで固
定します。 (1 項参照)
A-6-2. リア上パネ U5 サブ Ass y を外します。 (A-1 項参照)
A-6-3. [960] のネジ 4 本、[970A] のネジ 2 本、[N2] の六
角ナット 2 本と [970B] のネジ 2 本を外して、 JK シー
ト Ass y を外します。 (写真 12)
A-7. HAAD シート
(所要時間:約 12 分)
A-7-1. コンパネ U5 Ass y を開けて、サービスステイで固
定します。 (1 項参照)
A-7-2. リア上パネ U5 サブ Ass y を外します。 (A-1 項参照)
A-7-3. [850] のネジ 2 本を外して、FFC アングル FR を外
します。 (写真 13)
A-7-4. [750] の ネ ジ 16 本 と [820] の ネ ジ 2 本 を 外 し て、
HAAD シートを外します。 (写真 13)
FFC ANGLE FR
(FFC アングル FR)
[850] [820]
[750]
Photo 13 ( 写真 13)
CL3/CL1
HAAD
[820]
[850]
[750]
29