Yamaha CL3 Service Manual page 179

■ DANTE SOUND OUTPUT CHECK
1) Connect Dante of the CL unit and PC with the Ether cable.
2) Connect MIDI IN of the CL unit and USB port of PC with UX16.
3) After loading AllData (SEISAN1.CLF) for sound output check, turn on the Output button of OSCILLATOR on the monitor screen.
(For checking sound input/output of DANTE)
4) Activate Cubase (Sound output check of DSP6 on desk-top).
5) Activate Dante Virtual Sound (short-cut available on desk-top) and turn on the power marked switch of the setting tab.
6) After activating Dante Controller (short-cut available on desk-top), select File and then Load Preset to load "Dante DSP6 sound
output check preset".
Check to ensure that the screen appears as shown below.
If the screen is not as shown below, turn on Patch manually as follows.
7) Return to the beginning by using the
fi gure below) (the
side.)
Scenes 5 to 38 are recalled successively.
(Scene 37 represents the scene data when muted and Scene 38 represents the scene data for checking sound input/output of
DANTE.)
8) Confi rm that no noise is output for 15 seconds.
button of Cubase and press the red round
button is also usable for sound reproduction (check) but it is better to keep the recorded data on the Cubase
button for sound reproduction.(Refer to the
CL3/CL1
179