Table of Contents
Advertisement
p
B
II l / el
reparIng e
Ike
Note
Additional accessories required for load calibration of
eBike L / eBike EL:
•
calibration stay for eBike L / eBike EL
(P/N 2018111-134 SPARE EBIKE L&EL SUPPORT FOR
CALIBRATION)
•
8-kg calibration weight for eBike L / eBike EL
(P/N 2018111-135 SPARE EBIKE L&EL CALIBRATION
WEIGHT 8KG)
•
2nd persons to assist in lifting the couch ergometer
•
Place the ergometer on a level surface and put it into
operation.
•
Set the back rest of eBike L to an angle of 45° (semi-
recumbent position), using the remote control.
Adjust eBike EL to a lateral tilt of 0°, using the
remote control.
•
Then set the back rest to an angle of 45° (semi-
recumbent position).
•
Turn the front castors of eBike L/EL to the back and
lock the castor brakes (see arrow a. in illustration).
•
To begin with, lift the eBike L/EL at the front, left hand
side and place the calibration support under the left
castor (see arrow b. in illustration).
Then lift the eBike L/EL at the front, right hand side
and place the calibration support under the right
castor.
Caution:
The castors must be located between the two border
strips (see arrow c. in illustration).
•
Extend the calibration stay to approx. 835 mm and
lock.
•
Hang the hook of the calibration weight adaptor into
the eye of the strain gauge return spring and let hang.
- 64 -
eBike II, eBike II L, eBike II EL
2018112-069 Rev. F
Advertisement
Table of Contents
