Table of Contents
Advertisement
r
eplaCe saddle Motor
Troubleshooting
•
Before replacing the saddle motor make sure that
the motor is actually defective.
•
For this check, switch the hexagon socket of the
saddlemotor from channel 3 to channel 1 or 2.
•
If the motor does not work, it is out of order and
must be replaced.
•
If the motor works, the motor control unit or the
hand switch is defective.
Before you can replace the saddle motor, the
connectionbox and the casing must be removed first.Then
follow these steps to replace the saddle motor:
•
Loosen both hexagon socket screws a. of the saddle
guide.
•
Remove pin b. with self-locking screw.
•
Disconnect plug of cable c. at motor control
(connector 3. in illustration). To do so, first turnjack
plug counterclockwise as far as possible (e.g. using a
suitable fork wrench), then pullout the jack plug.
Open cable tie and pull cable towards the saddlemotor.
Note
•
To facilitate pulling in the new saddle motor cable,
attach a draw rope to the cable of the old saddle-
motor
)
•
When mounting the new saddle motor, secure the
motor control connection cable with a cable tie d, as
shown in the illustration.
- 128 -
eBike II, eBike II L, eBike II EL
2018112-069 Rev. F
Advertisement
Table of Contents
