Exchange Motor Control Unit - GE eBike II Series Service Manual

e
xCHange Motor Control unIt
B
loCk dIagraM Motor Control unIt
remote control
e
xCHangIng tHe Motor Control unIt
Troubleshooting
• Before replacing the motor control unit make sure
that the motor is actually defective.
• For this check, use a new hand switch for eBike EL
and test the motorfunctions.
• If the control unit does not work, it is out of order
and must be replaced.
• If it works, the hand switch is defective.
• Disconnect device from mains!
• Disconnect all cables prior the disassembling of the
unit, using a suitable fork wrench or the special tool.
- 124 -
motor control
1
SUB-D
connector
2
3
on/off
switch
eBike II, eBike II L, eBike II EL
saddle motor
1
motor left side tilting
2
motor longitudinal tilting
3
for connector identification:
see „wiring diagrams"
power cord
2018112-069 Rev. F