Labels - Epson VT Series Manipulator Manual

1.7 Labels

The Manipulator has the following warning labels.
The warning labels are attached around the locations where specific dangers exist.
Be sure to comply with descriptions and warnings on the labels to operate and maintain
the Manipulator safely.
Do not tear, damage, or remove the warning labels. Use meticulous care when handling
those parts or units to which the following warning labels are attached as well as the
nearby areas.
Location
A
B
C
D
E
F
VT Rev.1
Warning Label
Before loosening the base mounting screws, hold the arm
and secure it tightly with a band to prevent hands or
fingers from being caught in the Manipulator.
For transport and install procedures, follow the steps
described in this manual.
Do not enter the operation area while the Manipulator is
moving. The robot arm may collide against the
operator. This is extremely hazardous and may result in
serious safety problems.
Hazardous voltage exists while the Manipulator is ON.
To avoid electric shock, do not touch any internal
electric parts.
When releasing the brakes, be careful of the arm falling
due to its own weight.
This warning label is attached on the Manipulator and
optional brake release box.
Only authorized personnel should perform sling work
and operate a crane and a forklift.
operations are performed by unauthorized personnel, it is
extremely hazardous and may result in serious bodily
injury and/or severe equipment damage to the robot
system.
You may get your hand or fingers caught when bringing
your hand close to moving parts.
Setup & Operation 1. Safety
NOTE
When these
11